User Tools
Sidebar
products:sbc:vim4:applications:gpio:adc
Table of Contents
VIM4 ADC
Introduction
This document aims to guide you on how to use the ADC (Analog-to-Digital Converter) interface on the GPIO pins of the Khadas VIM4 SBC. The ADC interface allows you to convert analog signals into digital values, providing you with flexibility to connect analog sensors and devices on the VIM4.
Hardware Information
The ADC is a 12-bit successive approximation register (SAR) A/D Converter.
| Pin | SIGNAL | Voltage | Device Node |
|---|---|---|---|
| 10 | ADC_CH6 | 0~1.8V | /sys/bus/iio/devices/iio:device0/in_voltage6_raw |
| 12 | ADC_CH3 | 0~1.8V | /sys/bus/iio/devices/iio:device0/in_voltage3_raw |
Get Raw ADC Value
Replace the variable x in in_voltageXraw with the corresponding channel value
$ cat /sys/bus/iio/devices/iio:device0/in_voltageX_raw
The following uses PIN10 as an example.
$ cat /sys/bus/iio/devices/iio:device0/in_voltage6_raw // PIN10 is connected to 1.8V 4082 $ cat /sys/bus/iio/devices/iio:device0/in_voltage6_raw // PIN10 connects to GND 5
Convert the raw ADC value to Voltage:
Voltage = (value / 4096) * 1.8V
Last modified: 2023/07/25 22:21 by nick