User Tools
products:sbc:vim2:hardware:interfaces
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
products:sbc:vim2:hardware:interfaces [2023/03/22 03:16] nick [Table] |
products:sbc:vim2:hardware:interfaces [2023/03/22 03:22] nick [Hardware buttons] |
||
|---|---|---|---|
| Line 33: | Line 33: | ||
| - | | ^ Component | + | | ^ Component |
| - | |1|Pogo Pads|External 5V power input, can be provided by vTV Board(DVB Tuner)| | + | | 1 | Pogo Pads |
| - | |2|Micro-SD Card Slot|Boot alternative OSes via a micro-SD card, or just for extra storage| | + | | 2 | Micro-SD Card Slot | Boot alternative OSes via a micro-SD card, or just for extra storage |
| - | |3|500mA Fuse|Fuse for the 500mA USB port| | + | | 3 | MCU |
| - | |4|WOL Switch|Power switch activated via Wake-On-LAN| | + | | 4 |
| - | |5|MCU|STM8S003 micro-controller with programmable EEPROM| | + | | 5 | M-Register |
| - | |6|MCU Pogo Pads|SWIM, UART, ADC, NRST| | + | | 6 |
| - | |7|SPI Flash|Flash memory module that interfaces over SPI| | + | | 7 |
| - | |8|20-Pin Pogo Pads|USB, I2C, DVB-Bus, IOs, for docking with the vTV Board(DVB Tuner)| | + | | 8 |
| - | |9|XPWR Pads|Connect an external power switch using these pads| | + | |
| - | |A|900mA Fuse|Fuse for the 900mA USB port| | + | |
| ===== Hardware buttons ===== | ===== Hardware buttons ===== | ||
| Line 50: | Line 48: | ||
| - | ^ Reset ^ Function | + | ^ Reset ^ Function |
| - | | x | | | + | | x | | |
| - | | | + | | |
| - | | | + | | |
| - | | x | | x | Enter Upgrade Mode (KEYS) | + | | x | | x | Enter Upgrade Mode (KEYS) |
| Special button shortcuts | Special button shortcuts | ||
| - | * Press '' | + | * Press '' |
| ===== GPIO header pinout ===== | ===== GPIO header pinout ===== | ||
Last modified: 2023/03/22 04:00 by nick