LibreELEC boots from external media (SD-Card), so you need to write the image to SD card.
- Download the Win32DiskImager.
- Extract and install it on your Windows PC.
- An SD Card and a Card Reader is required, make sure there is nothing important on your card as ALL the data will be erased after the following operations.
You can download LibreELEC images from Edge LibreELEC firmware page.
There are two ways to write a LibreELEC image to SD card:
- Run Win32DiskImager.
- Insert the SD card into your PC, it should appear as a new drive letter.
- Select the .img file and verify that the destination drive letter is correct, then click
- When the write-process is complete, you can safely remove the SD card by right-clicking on the drive in “Windows Explorer” and selecting “Eject”.
Get The SD Storage Device Node:
After you’ve inserted the SD-Card to your PC, use
dmesg | tail to find out which /dev/sdX it is located at.
You can also use
fdisk, It should look something similar to /dev/sdX:
$ sudo parted -l
Make sure the disk is unmounted:
$ sudo umount /dev/sdb1
dd to write the disk image into SD/USB card:
sudo dd if=LibreELEC-RK3399.arm-9.0-devel-20181219114346-cc816a4-khadas-edge.img of=/dev/sdb bs=4M && sync
sync flag is to ensure that all changes are synced to the SD card before removing it.
Eject the SD/USB card:
$ sudo eject /dev/sdb
Insert the SD card to SD card slot and reset the board by pressing the
RESET key then the system will boot from SD card.