This shows you the differences between two versions of the page.
Next revision | Previous revision Next revision Both sides next revision | ||
products:sbc:vim4:install-os:boot-into-upgrade-mode [2022/07/04 03:07] nick created |
products:sbc:vim4:install-os:boot-into-upgrade-mode [2022/09/02 05:25] nick |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Boot into Upgrade Mode ====== | + | ====== |
- | There are 4 ways to boot into upgrade mode: | + | In order to flash the OS into eMMC with USB Upgrade Tool, you need to put the board enter Upgrade Mode.\\ |
+ | |||
+ | <wrap info> | ||
* TST Mode (Recommended) | * TST Mode (Recommended) | ||
* Key Mode | * Key Mode | ||
* Serial Mode | * Serial Mode | ||
- | * Bootable | + | * Bootable |
<tabbox TST Mode (Recommended)> | <tabbox TST Mode (Recommended)> | ||
- Connect VIM4 to PC with a USB-C cable. | - Connect VIM4 to PC with a USB-C cable. | ||
- Quickly press the '' | - Quickly press the '' | ||
- | - After the Power LED (Red) turns OFF, this indicates that the board is in Upgrade Mode (Maskrom Mode). | + | - The Power LED (Red) turns OFF, which indicates that the board is in Upgrade Mode (Maskrom Mode). |
<tabbox Key Mode> | <tabbox Key Mode> | ||
- Connect VIM4 to PC with a USB-C cable. | - Connect VIM4 to PC with a USB-C cable. | ||
Line 22: | Line 24: | ||
- Once again, make sure you’ve done the correct connections and setup. | - Once again, make sure you’ve done the correct connections and setup. | ||
- Hit '' | - Hit '' | ||
- | - Type '' | + | - Type '' |
- | <tabbox Bootable | + | <tabbox Bootable |
- | - [[products: | + | - [[products: |
- | - Insert a Bootable | + | - Insert a Bootable |
- Refer to this guide to setup your serial tool for VIM4. | - Refer to this guide to setup your serial tool for VIM4. | ||
- Connect VIM4 to PC with a USB-C cable. | - Connect VIM4 to PC with a USB-C cable. |