This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
products:sbc:vim3:install-os:boot-into-upgrade-mode [2022/07/07 23:55] frank |
products:sbc:vim3:install-os:boot-into-upgrade-mode [2023/03/23 21:33] (current) nick |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Boot into Upgrade Mode ====== | + | {{indexmenu_n> |
- | ===== Introduction ===== | ||
- | ===== Into Upgrade Mode ===== | + | ====== VIM3/3L Boot into Upgrade Mode ====== |
- | <WRAP info > | ||
There are 4 ways to boot into upgrade mode: | There are 4 ways to boot into upgrade mode: | ||
+ | * TST Mode (Recommended) | ||
* Keys Mode (Side-Buttons) | * Keys Mode (Side-Buttons) | ||
* Serial Mode | * Serial Mode | ||
- | * TST Mode (Recommended) | ||
* MRegister Mode | * MRegister Mode | ||
+ | |||
+ | ===== TST Mode ===== | ||
+ | |||
+ | <WRAP tip > | ||
+ | TST Mode recommended as preferred upgrade mode | ||
</ | </ | ||
- | <tabbox TST Mode (Recommended)> | ||
- Connect VIM3 to PC with a USB-C cable. | - Connect VIM3 to PC with a USB-C cable. | ||
- Quickly press the '' | - Quickly press the '' | ||
- After the Power LED (Red) turns OFF, this indicates that the board is in Upgrade Mode (Maskrom Mode). | - After the Power LED (Red) turns OFF, this indicates that the board is in Upgrade Mode (Maskrom Mode). | ||
- | < | + | |
+ | ===== Key Mode ===== | ||
- Power on VIM3. | - Power on VIM3. | ||
Line 25: | Line 29: | ||
- Count for 2 to 3 seconds, then release the '' | - Count for 2 to 3 seconds, then release the '' | ||
- | < | + | ===== Serial Mode ===== |
- Connect VIM3 to PC with a USB-C cable. | - Connect VIM3 to PC with a USB-C cable. | ||
- | - Refer to [[products: | + | - Refer to [[products: |
- Once again, make sure you’ve done the correct connections and setup. | - Once again, make sure you’ve done the correct connections and setup. | ||
- Hit '' | - Hit '' | ||
- Type '' | - Type '' | ||
- | < | + | |
+ | ===== MRegister Mode ===== | ||
+ | |||
+ | - Power on VIM3. | ||
+ | - Use a tweezer to short-circuit the two pads of the M register, and without releasing… | ||
+ | - Short press the Reset key and then release it, to boot into upgroup mode | ||
+ | ===== Bootable TF Card ===== | ||
- [[products: | - [[products: | ||
- Insert a Bootable TF card into the slot. | - Insert a Bootable TF card into the slot. | ||
Line 38: | Line 50: | ||
- Hit '' | - Hit '' | ||
- Type '' | - Type '' | ||
- | </ | + |