This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
products:sbc:vim3:install-os:boot-into-upgrade-mode [2022/09/28 06:15] nick |
products:sbc:vim3:install-os:boot-into-upgrade-mode [2022/11/01 02:18] nick |
||
---|---|---|---|
Line 4: | Line 4: | ||
====== VIM3/3L Boot into Upgrade Mode ====== | ====== VIM3/3L Boot into Upgrade Mode ====== | ||
- | ===== Introduction ===== | ||
- | |||
- | ===== Into Upgrade Mode ===== | ||
- | |||
- | <WRAP info > | ||
There are 4 ways to boot into upgrade mode: | There are 4 ways to boot into upgrade mode: | ||
Line 15: | Line 10: | ||
* TST Mode (Recommended) | * TST Mode (Recommended) | ||
* MRegister Mode | * MRegister Mode | ||
- | </ | ||
- | < | + | ===== TST Mode (Recommended) |
- Connect VIM3 to PC with a USB-C cable. | - Connect VIM3 to PC with a USB-C cable. | ||
- Quickly press the '' | - Quickly press the '' | ||
- After the Power LED (Red) turns OFF, this indicates that the board is in Upgrade Mode (Maskrom Mode). | - After the Power LED (Red) turns OFF, this indicates that the board is in Upgrade Mode (Maskrom Mode). | ||
- | < | + | |
+ | ===== Key Mode ===== | ||
- Power on VIM3. | - Power on VIM3. | ||
Line 28: | Line 25: | ||
- Count for 2 to 3 seconds, then release the '' | - Count for 2 to 3 seconds, then release the '' | ||
- | < | + | ===== Serial Mode ===== |
- Connect VIM3 to PC with a USB-C cable. | - Connect VIM3 to PC with a USB-C cable. | ||
- Refer to [[products: | - Refer to [[products: | ||
Line 34: | Line 32: | ||
- Hit '' | - Hit '' | ||
- Type '' | - Type '' | ||
- | < | + | |
+ | ===== Bootable TF Card ===== | ||
- [[products: | - [[products: | ||
- Insert a Bootable TF card into the slot. | - Insert a Bootable TF card into the slot. | ||
Line 41: | Line 41: | ||
- Hit '' | - Hit '' | ||
- Type '' | - Type '' | ||
- | </ | + |