This shows you the differences between two versions of the page.
Next revision | Previous revision Next revision Both sides next revision | ||
products:sbc:vim3:install-os:boot-into-upgrade-mode [2022/07/06 10:15] 127.0.0.1 external edit |
products:sbc:vim3:install-os:boot-into-upgrade-mode [2022/11/01 02:15] nick |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Boot into Upgrade Mode ====== | + | {{indexmenu_n> |
+ | ====== VIM3/3L Boot into Upgrade Mode ====== | ||
+ | |||
+ | ===== Boot Into Upgrade Mode ===== | ||
+ | |||
+ | <WRAP info > | ||
+ | There are 4 ways to boot into upgrade mode: | ||
+ | |||
+ | * Keys Mode (Side-Buttons) | ||
+ | * Serial Mode | ||
+ | * TST Mode (Recommended) | ||
+ | * MRegister Mode | ||
+ | </ | ||
+ | |||
+ | <tabbox TST Mode (Recommended)> | ||
+ | - Connect VIM3 to PC with a USB-C cable. | ||
+ | - Quickly press the '' | ||
+ | - After the Power LED (Red) turns OFF, this indicates that the board is in Upgrade Mode (Maskrom Mode). | ||
+ | <tabbox Key Mode> | ||
+ | |||
+ | - Power on VIM3. | ||
+ | - Long press the '' | ||
+ | - Short press the '' | ||
+ | - Count for 2 to 3 seconds, then release the '' | ||
+ | |||
+ | <tabbox Serial Mode> | ||
+ | - Connect VIM3 to PC with a USB-C cable. | ||
+ | - Refer to [[products: | ||
+ | - Once again, make sure you’ve done the correct connections and setup. | ||
+ | - Hit '' | ||
+ | - Type '' | ||
+ | <tabbox Bootable TF Card> | ||
+ | - [[products: | ||
+ | - Insert a Bootable TF card into the slot. | ||
+ | - Refer to this guide to setup your serial tool for VIM3. | ||
+ | - Connect VIM3 to PC with a USB-C cable. | ||
+ | - Hit '' | ||
+ | - Type '' | ||
+ | </ |