Differences

This shows you the differences between two versions of the page.

--- products:sbc:vim2:install-os:boot-into-upgrade-mode [2022/07/08 03:32]
127.0.0.1 external edit
+++ products:sbc:vim2:install-os:boot-into-upgrade-mode [2024/05/22 21:08] (current)
nick
@@ Line 1: / Line 1: @@
-====== Boot into Upgrade Mode ======
+{{indexmenu_n>30}}
+====== VIM2 Boot into Upgrade Mode ======
 ===== Introduction =====
@@ Line 6: / Line 9: @@
 <WRAP info >
-There are 4 ways to boot into upgrade mode:
+There are 5 ways to boot into upgrade mode:
+  * TST Mode (Recommended)
   * Keys Mode (Side-Buttons)
   * Serial Mode
-  * TST Mode (Recommended)
   * MRegister Mode
 </WRAP>
 <tabbox TST Mode (Recommended)>
-  - Connect VIM1 to PC with a USB-C cable.
+  - Connect VIM2 to PC with a USB-C cable.
   - Quickly press the ''Function'' key **3 times in 2 seconds**, then release the key. You will see the Power LED (Blue) blink for about 3 seconds.
   - After the Power LED (Blue) turns OFF, this indicates that the board is in Upgrade Mode (Maskrom Mode).
+<WRAP important >
+Only for VIM2 V14 version.
+</WRAP>
 <tabbox Key Mode>
-  - Power on VIM1.
+  - Power on VIM2.
   - Long press the ''POWER'' key without releasing it.
   - Short press the ''Reset'' key and release it.
@@ Line 31: / Line 39: @@
   - Hit ''SPACE'' on your keyboard at the moment of bootup to stop autoboot. This step will let VIM1 boot into U-Boot command line.
   - Type ''run update'' in the terminal of U-Boot. The Sys LED (White) will turn ON when you’ve entered Upgrade Mode.
-<tabbox Bootable TF Card>
+<tabbox MRegister Mode>
-  - [[products:sbc:vim1:development:create-bootable-tf-card|Create a Bootable TF Card]].
+  - Connect VIM2 to PC with a USB-C cable.
-  - Insert a Bootable TF card into the slot.
+  - Use the tweezers to shourtcut the MRegiser pad.
-  - Refer to this guide to setup your serial tool for VIM1.
+  - Short press the ''Reset'' key to enter upgrade mode.
-  - Connect VIM1 to PC with a USB-C cable.
-  - Hit ''SPACE'' key at the moment of bootup to stop autoboot. This step will let VIM1 boot into U-Boot.
+  * MRegister location for V14 version board
-  - Type ''run update'' in the U-Boot terminal.
+{{:products:sbc:vim2:vim2-mregister-short-circuit-v14.webp?400|}}
+  * MRegister location for V12 version board
+{{:products:sbc:vim2:vim2-mregister-short-circuit-v12.webp?400|}}
+<WRAP tip >
+The Mregister is located on the underside of VIM2.
+</WRAP>
 </tabbox>

Khadas Docs

User Tools

Site Tools

Differences

Page Tools