products:sbc:vim1s:install-os:install-os-into-emmc-via-usb-tool

This is an old revision of the document!

Table of Contents

VIM1S Install OS into eMMC via USB Flash Tool
Discussion

VIM1S Install OS into eMMC via USB Flash Tool

Preparation

Dowload the USB Upgrade Tool and extract it to somewhere.

Install USB Drivers

Goto directory V3\Driver and double click dpscat.exe to install. Please note there is no GUI display.
Goto directory V3\Driver and double click dpinst64.exe to install.

Install the OS

Goto root directory double click Aml_Burn_Tool.exe to open the USB upgrade tool.
Click Setup–>Load Image, then choose an OS image for your board.
Connect your board to your PC with a USB-C cable (the board will power on automatically).
Put your board into Upgrade Mode.
If you have correctlyperformed steps 3 and 4, your PC will automatically discover your board as an attached USB device.
Now what you need to do is to click the Start button and wait for the process to complete.

Click the Stop button to interrupt flashing, then close the USB Upgrade Tool. Note that the eMMC may have already been completely erased if you went past the 15% mark.
An External Power Supply may be required when your PC cannot provide enough electrical power for the burning process.
If your system is a 32-bit system, please select dpinst32.exe when installing the driver.

Install OS into eMMC on Ubuntu

Please check install-os-into-emmc-on-ubuntu.

Last modified: 2022/09/28 06:46 by nick

Khadas Community

Khadas Downloads