This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
products:sbc:edge2:install-os:boot-into-upgrade-mode [2022/09/02 03:30] nick |
products:sbc:edge2:install-os:boot-into-upgrade-mode [2022/09/27 23:55] (current) nick |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | {{indexmenu_n> | ||
+ | |||
+ | |||
====== Edge2 Boot into Upgrade Mode ====== | ====== Edge2 Boot into Upgrade Mode ====== | ||
Line 5: | Line 8: | ||
<WRAP info > | <WRAP info > | ||
- | There are 4 ways to boot into upgrade mode: | + | There are 3 ways to boot into upgrade mode: |
* TST Mode (Recommended) | * TST Mode (Recommended) | ||
Line 15: | Line 18: | ||
- Connect Edge2 to PC with a USB-C cable. | - Connect Edge2 to PC with a USB-C cable. | ||
- Quickly press the '' | - Quickly press the '' | ||
- | - After the Power LED (Red) turns OFF, this indicates that the board is in Upgrade Mode (Maskrom Mode). | + | - After the '' |
<tabbox Serial Mode> | <tabbox Serial Mode> | ||
Line 22: | Line 25: | ||
- Once again, make sure you’ve done the correct connections and setup. | - Once again, make sure you’ve done the correct connections and setup. | ||
- Hit '' | - Hit '' | ||
- | - Type '' | + | - Type '' |
- | - Or type '' | + | |
<tabbox Linux Command Line> | <tabbox Linux Command Line> | ||
- | - Refer to this [[/ | + | - Refer to this [[/ |
- Once again, make sure you’ve done the correct connections and setup. | - Once again, make sure you’ve done the correct connections and setup. | ||
- Boot into Android or Linux command line. | - Boot into Android or Linux command line. | ||
- | - For Linux, execute sudo reboot loader. For Android, execute su and reboot loader. The system will reboot and enter Upgrade Mode. You will see the sys-led | + | - For Linux, execute |
</ | </ | ||