Differences

This shows you the differences between two versions of the page.

--- products:sbc:edge2:install-os:boot-into-upgrade-mode [2022/09/27 23:55]
nick
+++ products:sbc:edge2:install-os:boot-into-upgrade-mode [2024/12/17 02:32] (current)
nick
@@ Line 16: / Line 16: @@
 <tabbox TST Mode (Recommended)>
-  - Connect Edge2 to PC with a USB-C cable.
+  - Connect Edge2 **Type C port 2** to PC with a USB-C cable.
+    - {{:products:sbc:edge2:hardware:edge2-interfaces-top-side.webp?600|}}
   - Quickly press the ''Function'' key **3 times in 2 seconds**, then release the key. You will see the Power LED (Red) blink for about 3 seconds.
   - After the ''Power LED'' (Red) turns OFF, this indicates that the board is in Upgrade Mode (Maskrom Mode).
 <tabbox Serial Mode>
-  - Connect Edge2 to PC with a USB-C cable.
+  - Connect Edge2 **Type C port 2** to PC with a USB-C cable.
+    - {{:products:sbc:edge2:hardware:edge2-interfaces-top-side.webp?600|}}
   - Refer to [[products:sbc:edge2:development:setup-serial-tool|Setup Serial Tool]] to setup your Serial Tool for Edge2.
   - Once again, make sure you’ve done the correct connections and setup.

Khadas Docs