This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
products:sbc:edge2:development:setup-serial-tool [2022/12/05 00:17] hyphop [Hardware Connection] |
products:sbc:edge2:development:setup-serial-tool [2023/04/03 22:30] (current) nick |
||
---|---|---|---|
Line 9: | Line 9: | ||
Take a serial tool, which is also known as an USB to TTL Converter like [[https:// | Take a serial tool, which is also known as an USB to TTL Converter like [[https:// | ||
- | An [[|Edge2 IO board]] is needed to work with the serial tool. | + | An [[/ |
Line 15: | Line 15: | ||
{{/ | {{/ | ||
+ | |||
+ | ^ ^ USB-TTL pin name ^ Edge2 GPIO name ^ GPIO pin ^ | ||
+ | | 1 | '' | ||
+ | | 2 | '' | ||
+ | | 3 | '' | ||
+ | |||
+ | Full [[/ | ||
+ | | ||
+ | /* IMHO its ugly | ||
You can connect your serial tool to the board GPIO pins, referring to the following diagram, | You can connect your serial tool to the board GPIO pins, referring to the following diagram, | ||
Line 22: | Line 31: | ||
* Tool Pin '' | * Tool Pin '' | ||
+ | */ | ||
===== Setup Serial Communication Program ===== | ===== Setup Serial Communication Program ===== | ||
Line 148: | Line 158: | ||
Install the CH340 driver. | Install the CH340 driver. | ||
- | - Download the [[https:// | + | - Download the [[https:// |
- Unzip the compressed file. | - Unzip the compressed file. | ||
- Run the installer. | - Run the installer. |