This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
products:sbc:edge2:development:setup-serial-tool [2022/09/28 08:16] nick |
products:sbc:edge2:development:setup-serial-tool [2023/04/03 22:30] (current) nick |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Edge2 Setup Serial | + | ====== Edge2 Setup Serial |
===== Introduction ===== | ===== Introduction ===== | ||
Line 7: | Line 7: | ||
===== Preparation ===== | ===== Preparation ===== | ||
- | Take a Serial Debugging Tool, which is also known as an USB to TTL Converter like [[https:// | + | Take a serial tool, which is also known as an USB to TTL Converter like [[https:// |
+ | |||
+ | An [[/ | ||
===== Hardware Connection ===== | ===== Hardware Connection ===== | ||
- | {{ / | + | {{/ |
- | You can connect your serial tool to the board GPIO pins, referring to the following diagram, | + | ^ ^ USB-TTL pin name ^ Edge2 GPIO name ^ GPIO pin ^ |
+ | | 1 | '' | ||
+ | | 2 | '' | ||
+ | | 3 | '' | ||
- | * Tool Pin '' | + | Full [[/ |
- | * Tool Pin '' | + | |
- | * Tool Pin '' | + | /* IMHO its ugly |
- | * Tool Pin '' | + | |
+ | You can connect your serial tool to the board GPIO pins, referring to the following diagram, | ||
- | Insert the USB port into your computer. | + | * Tool Pin '' |
+ | * Tool Pin '' | ||
+ | * Tool Pin '' | ||
- | | + | */ |
- | * Orange line: '' | + | |
- | * Black line: '' | + | |
===== Setup Serial Communication Program ===== | ===== Setup Serial Communication Program ===== | ||
<WRAP important > | <WRAP important > | ||
- | * Edge2 Baudrate: **1500000** | + | Edge2 Baudrate: **1500000** |
</ | </ | ||
Line 151: | Line 158: | ||
Install the CH340 driver. | Install the CH340 driver. | ||
- | - Download the [[https:// | + | - Download the [[https:// |
- Unzip the compressed file. | - Unzip the compressed file. | ||
- Run the installer. | - Run the installer. |