Differences

This shows you the differences between two versions of the page.

--- products:sbc:edge2:development:setup-serial-tool [2022/09/28 08:16]
nick
+++ products:sbc:edge2:development:setup-serial-tool [2022/12/05 05:19]
hyphop [Hardware Connection]
@@ Line 1: / Line 1: @@
-====== Edge2 Setup Serial Tool ======
+====== Edge2 Setup Serial Debug Console ======
 ===== Introduction =====
@@ Line 7: / Line 7: @@
 ===== Preparation =====
-Take a Serial Debugging Tool, which is also known as an USB to TTL Converter like [[https://www.amazon.com/Adaptor-Download-Adapter-Converter-LinkMore/dp/B08VGRRJ67/ref=sr_1_4?dchild=1&keywords=USB+to+TTL+ch340&qid=1629184609&sr=8-4|CH340 USB to TTL Converter]].
+Take a serial tool, which is also known as an USB to TTL Converter like [[https://www.amazon.com/Adaptor-Download-Adapter-Converter-LinkMore/dp/B08VGRRJ67/ref=sr_1_4?dchild=1&keywords=USB+to+TTL+ch340&qid=1629184609&sr=8-4|CH340 USB to TTL Converter]].
+An [[/products/sbc/edge2/applications/gpio/40pin-header|Edge2 IO board]] is needed to work with the serial tool.
 ===== Hardware Connection =====
-{{ /products/sbc/edge2/development/serial_connections_3pin.png?500|serial_connections}}
+{{/products/sbc/edge2/development/edge2-io.webp?500|serial_connections}}
-You can connect your serial tool to the board GPIO pins, referring to the following diagram，
+^  ^ USB-TTL pin name  ^ Edge2 GPIO name ^ GPIO pin ^
+| 1 | ''GND''      | ''GND'' | 4 |
+| 2 | ''TXD''      | ''DRX'' | 3 |
+| 3 | ''RXD''      | ''DTX'' | 2 |
-  * Tool Pin ''GND'' <-> ''Pin17'' of VIM’s GPIO
+Full [[/products/sbc/edge2/applications/gpio/40pin-header#reference-table| Edge2 GPIO header - reference table]]
-  * Tool Pin ''TXD'' <-> ''Pin18'' of VIM’s GPIO ''Linux_Rx''
-  * Tool Pin ''RXD'' <-> ''Pin19'' of VIM’s GPIO ''Linux_Tx''
+/* IMHO its ugly
-  * Tool Pin ''VCC'' <-> ''Pin20'' of VIM’s GPIO
+You can connect your serial tool to the board GPIO pins, referring to the following diagram，
-Insert the USB port into your computer.
+  * Tool Pin ''GND'' <-> ''Pin1'' of Edge2 IO's GPIO
+  * Tool Pin ''TXD'' <-> ''Pin2'' of Edge2 IO's GPIO ''DRX''
+  * Tool Pin ''RXD'' <-> ''Pin3'' of Edge2 IO's GPIO ''DTX''
-  * Blue line: ''TXD''
+*/
-  * Orange line: ''RXD''
-  * Black line: ''GND''
 ===== Setup Serial Communication Program =====

Khadas Docs

User Tools

Site Tools

Differences

Page Tools