This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
products:sbc:edge1:install-os:boot-into-upgrade-mode [2022/07/13 22:48] nick |
products:sbc:edge1:install-os:boot-into-upgrade-mode [2022/11/22 21:27] (current) nick |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | {{indexmenu_n> | ||
+ | |||
+ | |||
====== Edge1 Boot into Upgrade Mode ====== | ====== Edge1 Boot into Upgrade Mode ====== | ||
===== Introduction ===== | ===== Introduction ===== | ||
- | ===== Into Upgrade Mode ===== | ||
<WRAP info > | <WRAP info > | ||
- | There are 4 ways to boot into upgrade mode: | + | There are 5 ways to boot into upgrade mode: |
- | * Keys Mode (Side-Buttons) | ||
- | * Serial Mode | ||
* TST Mode (Recommended) | * TST Mode (Recommended) | ||
- | * MRegister Mode | + | |
+ | * Serial Mode | ||
+ | * Linux/ | ||
+ | | ||
</ | </ | ||
Line 18: | Line 21: | ||
- Quickly press the '' | - Quickly press the '' | ||
- After the Power LED (Red) turns OFF, this indicates that the board is in Upgrade Mode (Maskrom Mode). | - After the Power LED (Red) turns OFF, this indicates that the board is in Upgrade Mode (Maskrom Mode). | ||
+ | |||
<tabbox Key Mode> | <tabbox Key Mode> | ||
Line 31: | Line 35: | ||
- Hit '' | - Hit '' | ||
- Type '' | - Type '' | ||
- | < | + | - Type '' |
- | - [[products:sbc:edge1:development:create-bootable-tf-card|Create a Bootable TF Card]]. | + | |
- | - Insert a Bootable TF card into the slot. | + | < |
- | - Refer to this guide to setup your serial tool for Edge1. | + | - Refer to this [[/products/sbc/edge1/development/setup-serial-tool|guide]] to setup your serial tool for Edge. |
- | - Connect Edge1 to PC with a USB-C cable. | + | - Once again, make sure you’ve done the correct connections and setup. |
- | - Hit '' | + | - Boot into Android or Linux command line. |
- | - Type '' | + | - For Linux, execute sudo reboot loader. For Android, execute su and reboot loader. The system will reboot and enter Upgrade Mode. You will see the sys-led turn ON when you’ve entered Upgrade Mode (Loader Mode). |
+ | |||
+ | <tabbox MRegister Mode(Maskrom Mode)> | ||
+ | |||
+ | - Power-on Edge. | ||
+ | - Use a tweezer to short-circuit the two pads of '' | ||
+ | - Short press the '' | ||
+ | |||
+ | {{products: | ||
</ | </ |