Differences

This shows you the differences between two versions of the page.

--- products:sbc:common:applications:gsensor [2022/08/07 22:51]
olivia [Introduction]
+++ products:sbc:common:applications:gsensor [2026/02/03 22:53] (current)
gray update by using AI
@@ Line 3: / Line 3: @@
 ===== Introduction =====
-This page introduces G-Sensor. You will know which node of G-Sensor is, and how to read the value of G-Sensor through C program.
+This guide explains how to identify the G-Sensor device node and read acceleration data from it using a C program.
 ===== System Configuration =====
-Check G-sensor node.
+Verify the G-Sensor device node exists:
 ```shell
 $ ll /dev/accel
+```
+Expected output:
+```shell
 crw-rw-rw- 1 root root 10, 50 Mar 18 12:17 /dev/accel
 ```
@@ Line 16: / Line 19: @@
 ===== Demo Source Code =====
-The source code only realizes the use of default settings to read data, for other functions, you can implement them by yourself.
+The following sample program demonstrates reading data from the G-Sensor using default settings. You can extend it to implement other functions.
 ```c gsensor_sample_data.c
@@ Line 83: / Line 86: @@
 ```
-Compile the source code obtained.
+Compile the program:
 ```shell
@@ Line 91: / Line 94: @@
 ===== Demonstrate =====
-Rotate the board while running, you can see the changes in G-Sensor data.
+Run the compiled program. While it is running, tilt or move the board to observe changes in the acceleration values.
 ```shell
-$ ./gsensor_sample_demo
+$ sudo ./gsensor_sample_demo
 gsensor node open success!!!
 gsensor start sueecss !!!

Khadas Docs

User Tools

Site Tools

Differences

Page Tools