{{indexmenu_n>20}}


====== VIM1S Install OS into eMMC via USB Flash Tool ======

===== Install OS into eMMC on Ubuntu =====


==== Preparation ====

Dowload the [[dl>products/vim1s/tool/aml-burn-tool-v3.2.0.zip|USB Upgrade Tool ]] and extract it to somewhere.

==== Install USB Drivers  ====
 
  - Goto directory ''V3\Driver'' and double click ''dpscat.exe'' to install. Please note there is no GUI display.
  - Goto directory ''V3\Driver'' and double click ''dpinst64.exe'' to install.

==== Install the OS ====

  - Goto root directory double click ''Aml_Burn_Tool.exe'' to open the USB upgrade tool.
  - Click ''Setup-->Load Image'', then choose an [[dl>products/vim1s/firmware/ | OS image]] for your board.
  - Connect your board to your PC with a USB-C cable (the board will power on automatically).
  - Put your board into [[boot-into-upgrade-mode | Upgrade Mode]].
  - If you have  correctlyperformed steps 3 and 4, your PC will automatically discover your board as an attached USB device.
  - Now what you need to do is to click the ''Start'' button and wait for the process to complete.

{{products:sbc:vim4:install-os:usb-upgrade-tool-interface-en.png?800|}}


<WRAP info>

  * Click the ''Stop'' button to interrupt flashing, then close the USB Upgrade Tool. Note that the eMMC may have already been completely erased if you went past the 15% mark.
  * An [[products:sbc:vim1s:hardware:external-power-supply | External Power Supply]] may be required when your PC cannot provide enough electrical power for the burning process.
  * If your system is a 32-bit system, please select ''dpinst32.exe'' when installing the driver.

</WRAP>

===== Install OS into eMMC on Ubuntu =====
{{page>products/sbc/common/install-os/install-os-into-emmc-on-ubuntu&noheader}}